Print Page - P0.14 / Reset control

Title: P0.14 / Reset control
Post by: steven_vh on September 27, 2006, 06:25:27 AM

Hi,
in the PLC2xxx version of the serial I/F in the user manual it says "DTR and RTS need to be connected to RST and P0.14", which I'd interpret as "... respectively". However, the schematic on page 46 shows DTR controlling P0.14 and RTS controlling /RST.
Which one is correct?
TIA
Steven

Title: Re: P0.14 / Reset control
Post by: Andy Ayre on September 27, 2006, 08:41:07 AM

Oops. DTR controls RST and RTS controls P0.14, so the diagram is backwards. I'll fix that today with a new release. Thanks for pointing this out.

Title: Re: P0.14 / Reset control
Post by: Andy Ayre on September 27, 2006, 09:15:01 AM

Fixed in current version (installer reports version 3.30b).

Title: Re: P0.14 / Reset control
Post by: steven_vh on September 27, 2006, 10:57:30 PM

Thanks for the quick reply, Andy.

Title: Re: P0.14 / Reset control
Post by: steven_vh on September 28, 2006, 12:47:12 AM

Er.. just downloaded again, but it still says version 3.30?

Title: Re: P0.14 / Reset control
Post by: Andy Ayre on September 28, 2006, 09:56:32 AM

I just tried it and the installer, release notes and application all say 3.31. Maybe your browser has cached the executable? I'm using the latest version of FireFox.

Flash Magic Forum

In-System Programming Support => LPC2xxx => Topic started by: steven_vh on September 27, 2006, 06:25:27 AM