Hi friends,
I am new to this community.Well I have a small doubt. can any one help me?
I have one ".hex" file and while I am trying to write this file to LPC2468 flash memory using flash magic
I am getting message
"failed to read the device signature.Accessing a device using the wrong protocol could render the device
unusable. do you wish to continue?"
I made the settings as below
COM port COM1
Baud rate 115200
Device LPC2468
Interface ISP(None)
Osc Freq 12 MHz
The device is probably not entering ISP mode. Try going to the ISP menu and attempting to read the device signature. If you are using an off the shelf board then double-check your jumper settings. Also look here:
http://www.flashmagictool.com/debugstart.html
Andy
I am facing the same problem and tried your solution but no success :(
I think i have gone wrong somehere. something thats too obvious and overlooked
I have enabled the ISP_E jumper in LPC2378-SK board
I tried connecting to the board with the following settings:
. 8 bits
· No parity
· One stop bit
· No handshaking or flow control
· 9600 baud
· No local echo
I checked the Serial Cable also by short circuiting Tx and Rx pins its fine
I am using a generic Serial Cable (Do we need some special cable ????)
I couldn't get the echo on sending '?' to the device
Pls help !!!
You need to check that you are meeting the requirements to place the device into ISP mode. I believe on this device it is holding a pin on port 2 low during reset. So put a scope on the reset pin and the ISP pin and make sure it is low during reset.
If it is then put a scope on the RxD pin of the device and make sure the '?' is arriving. Next check the TxD pin. More details are here:
http://www.flashmagictool.com/debugstart.html
Andy