Hi people !
I'm working with the LPC915 and a strange problem happened. When I set the lock bits (bit 0) block 0 and 1, the P0.1 and P1.0 don't work.
I have a LED in P0.1 and a simple output in P1.0.
I need these pins for the signal output.
What's happening ?
Does someone have the same problem ?
Thanks in advanced.
Jorge
This Forum is inteded for FlashMagic issues, and not general '51/LPC9xx questions; hence it's not likely you will get a relevant answer here.
You should perhaps consider posting the same question on the 8052.com Forum.
JW
Hi Jan,
See Erik's post here suggesting he posts the query here.
http://www.8052.com/forum/thread.phtml?thread=147797
It may be FM related, as he's setting the lock bits via FM.
and the resolution is there as well.
It was, if you do not take things too far, a 'programming problem. He programmed to protect an area where he read code from.
Erik