Flash Magic Forum

In-System Programming Support => P89C51Rx+/P89C51Rx2/P89C66x/P89C6xX2/P89V66x => Topic started by: xtracool_protik on March 27, 2008, 12:39:28 AM

Title: 89c51re2
Post by: xtracool_protik on March 27, 2008, 12:39:28 AM
Hello Guys,
This is my first time to use ISP and I am looking towards flashmagic, However when I looked in supported device list there was no 89C51RE2 so wanted any of you to guide me about it. I'm using 89c51RE2 because it have 2 serial ports which is must in my case.
Thank you in advance.
Title: Re: 89c51re2
Post by: Jan Waclawek on March 27, 2008, 01:06:04 AM
It is vital always to use the full marking of the part, including the prefix (OK you might omit the suffixes denoting the package/temperature grade).
There is no Philips/NXP made chip with RE2 suffix; and FlashMagic is a NXP-sponsored project, aimed at programming NXP-chips. You are most probably talking about Atmel's AT89C51RE2, for which the proper programming tool is FLIP, to be found at Atmel's webpages.

JW
Title: Re: 89c51re2
Post by: xtracool_protik on March 27, 2008, 05:52:30 AM
Ya I've seen that and really sorry for no prefix but you are right its atmel's.
I have FLIP but I've heard flash magic is good
So can you help me about FLIP
I want 2 serial port and atmel offers it only with re2 and I'm familiar with atmel instruction set thats why I'm using it
Thank you
Title: Re: 89c51re2
Post by: Jan Waclawek on March 27, 2008, 06:04:00 AM
I don't quite understand what's your problem with FLIP, but anyway, as this is a FlashMagic-specific forum, you better should repost your question on the 8052.com's Forum (please observe the rules for posting there).

JW