Trying to program 2378 on mcb2300 board using flashmagic serial port.
As far as I can tell, the board is setup to program using serial port. The jumper settings are as follows:
J10 - ISP is IN (ON)
J13 - ETM is OUT (OFF)
When you try to program, it fails to autobaud - with the message - autobaud failed - step 1
If I try to read the device signature, it is the same response.
I have seen some posts on this but no clear answers as to what is wrong.
I would think that this should be the simplest thing to do i.e. program the device using serial port with a utility that is designed to do this?
Any suggestions?
Thanks
My MCB2300 version 3.1 board is set up as follows:
J2, J1, J10, J3, J11, J8, J9, J6, J5 = on
J13 = off
Cable is connected to COM0 (I've made the mistake before of connecting to COM1).
No JTAG interface connected.
Power from USB.
Flash Magic is set to:
LPC2388
COM 1
19200 baud
Interface: None (ISP)
Oscillator: 12.000
Advanced Options -> Communications -> High Speed = off
Advanced Options -> Communications -> Half duplex = off
Advanced Options -> Hardware Config -> Use DTR and RTS to control RST and P0.14 = on
Advanced Options -> Hardware Config -> all other options are off
Advanced Options -> Hardware Config -> T1 = 50, T2 = 100
Advanced Options -> Timeouts -> Use my timeouts = off
I'm using a PC with a built in COM port. USB to RS232 cables can be problematic and would be the first thing I would suspect.
ISP would appear simple initially, but in fact there are a lot of variables to consider.
Andy
Thanks !!!!
I solve the problem with Advanced Options -> Hardware Config -> Use DTR and RTS to control RST and P0.14 = on
Advanced Options -> Hardware Config -> all other options are off