Print Page - ISP Entry using DTR and RTS

Title: ISP Entry using DTR and RTS
Post by: Nor_Ain on June 07, 2013, 08:02:53 AM

Hello all,

I'm try to implement the DTR and RTS signal to enter the ISP mode and RESET.
However, I'm facing a problem with the DTR and RTS signal. Do i need to connect the DTR and RTS from RS232 directly into 74LS125 chip? Or I need a
RS232 tranceiver chip to connect these DTR and RTS?

Any help highly appreciated.

Thanks.

Title: Re: ISP Entry using DTR and RTS
Post by: Andy Ayre on June 10, 2013, 01:32:39 AM

RS232 does not use TTL logic levels. You can either use an RS232 transceiver or you can use transistors. Please see the schematics of the Keil evaluation boards on keil.com for ideas.

Andy

Title: Re: ISP Entry using DTR and RTS
Post by: govind on January 02, 2014, 12:54:30 AM

please send me ciruit diagram of flash magic programmer.

Title: Re: ISP Entry using DTR and RTS
Post by: Andy Ayre on January 02, 2014, 01:05:42 AM

We recommend you start off with an evaluation board from a well known manufacturer. They always include circuit diagrams.

Andy

Flash Magic Forum

In-System Programming Support => P89C51Rx+/P89C51Rx2/P89C66x/P89C6xX2/P89V66x => Topic started by: Nor_Ain on June 07, 2013, 08:02:53 AM