Print Page - invalid value or command sent.please try the operation again.(nothing to erase)

Title: invalid value or command sent.please try the operation again.(nothing to erase)
Post by: eshwar on June 14, 2016, 10:48:24 PM

Hi,

I bought the MYDLPC development board Containing LPC4357 Micro controller. i got the sample hex files for LED blink,ADC,Timer etc with that board.I am using Flash magic version 7.02.2932 to download the hex files to the LPC board.I successfully download the LED blink hex file to the board but when i am trying to download the other hex files i am getting the error "invalid value or command sent.please try the operation again.(nothing to erase)". so i can't download the hex file to the board.i checked the device signature in ISP option. it reads the device.where i am doing the mistake. please suggest me.

thanks

Eshwar

Title: Re: invalid value or command sent.please try the operation again.(nothing to erase)
Post by: Andy Ayre on June 15, 2016, 05:46:37 AM

In section three of the main window click on the "Info" link. What does it show? Can you post a screenshot?

Andy

Title: Re: invalid value or command sent.please try the operation again.(nothing to erase)
Post by: eshwar on June 15, 2016, 09:40:06 PM

thanks for your reply. i attached the screen shot.please find the following attachment.

Title: Re: invalid value or command sent.please try the operation again.(nothing to erase)
Post by: Andy Ayre on June 16, 2016, 12:56:58 AM

Your screenshot is such low resolution that I can't read anything!

However, I can just make out that it says 0.00% of the device is used. So my guess is that none of the data in the hex file is inside the memory range of the microcontroller.

Flash Magic Forum

In-System Programming Support => ARM Cortex => Topic started by: eshwar on June 14, 2016, 10:48:24 PM