Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - nimish

#1
LPC2xxx / Re: LPC 2148 FAILED TO AUTOBAUD
October 28, 2016, 04:00:09 AM
Hi Andy,

I went to the technical support team of the place we bought the USB to RS232 connector from and they tested the converter as well as the board. The board is fine but the connector was failing the echo test.

I got a replacement as the debugging would've taken a while so I don't really know what was wrong with it; it could be either of the two ICs- Max232 and FT232RL.

I was told that a possible reason might be that the IC might have been affected by static. So this is for all the others who might happen upon this thread. Do perform the echo test once just to make sure your connector is functioning and avoid direct contact between fingers and the ICs, specially in winters.
#2
LPC2xxx / Re: LPC 2148 FAILED TO AUTOBAUD
October 17, 2016, 03:07:43 AM
Really appreciate the prompt, helpful response, Andy!

Which TXD and RXD do you think I should check? I am using a USB cable, a USB to serial adapter, and a serial cable. Which one out of these? Or all of them?

I am just hoping to narrow this down and hope that it's just a faulty cable because a faulty converter/development board will cost a lot of money as well as time, waiting for the new one to arrive.

#3
LPC2xxx / LPC 2148 FAILED TO AUTOBAUD
October 15, 2016, 10:55:00 PM
I was hoping you could help me. I am using the following:

Board: LPC 2148
Software: Flash Magic (latest version on the website)
USB to serial converter: From Nex Robotics (uses FT232RL).

Flash Magic returns a "failed to autobaud" error while copying the hex file to the board. It gives the same error even while reading the device signature.

This is the product I am using for USB to serial conversion. The development board and the converter are both from this vendor. I downloaded the driver from the link given on the page.
http://www.nex-robotics.com/products/usb-interfacing/usb-to-rs-232-converter.html

I have tried reinstalling the driver as well as changing the COM port number to a different unused one. Nothing seems to work. The COM port does appear in the device manager.

I tried using Realterm to see if I get a response by sending alphabets, but none appear on the screen. The TXD light does glow on the converter each time I type the alphabet.

A week ago, although I used to get the occasional autobaud error, I still managed to burn a few codes onto the board however now it seems to have stopped working completely. Now, I have no clue where the error lies.

Do respond at the earliest.

I have attached the Flash Magic Debug file.