Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - GGD77

#1
General Discussion / Re: Stall + Not authorized
April 16, 2018, 04:39:07 AM
Hi, will try doing it from my desktop at work. Currently my laptop with 10.9 programs and works correctly and I do not want to mess it up.
In any case, all 3 computers have always (independently from FM version) done the sound of USB connected device and all of them at 1st connection after installing/re-installing the driver have detected the "new device" and have installed the software. I even tried to connect the device before starting FM and vice-versa few times I also tried to reboot the computer after the first connection... until now... no joy

About the LED blinking on the device, it was always solid until I started the FM10.9 while the software was starting the LED started to blink and I thought it was a good sign. In fact, the elusive option to program the chip over the LPClink2 was there and allowed me to program the chip.

I tested one .hex from NXP works as detailed in the specs.
Regards
GGD
#2
General Discussion / Re: Stall + Not authorized
April 16, 2018, 03:22:33 AM
Hi, thanks for prompt reply

yes 3 different PCs give me the "not authorized" error at start-up. One of them (the 1st I tried) also hides the message in the background and I could not see it/read it. It was appearing briefly on the foreground of the opened windows only when I was killing the main FM process from task manager.

Anyway I tried the "roll-back the date trick" does not work.

RE removing JP1
this was the first thing advised in many forums/tutorials for FM including on the NXP documentation I have tried: no joy... and anyway the device was always recognized in device manager at each test.

Last minute update:

Version 10.9 without changing any settings on the LPC-link2 worked... I just did this trial end error uninstalling and re-installing driver+FM for all the versions I could download. the oldest and my last chance just did it... all the others give me the "not authorized" message

Just now I have successfully erased the NHS3152 chip in the evaluation kit I recently purchased. Later will try to flash one of the other example .hex I know can be downloaded from the NXP page.
Regards
GGD
#3
General Discussion / Re: Stall + Not authorized
April 16, 2018, 01:05:46 AM
Hello, I am new to flash magic but I worked with many processors before. I installed flash magic (latest downloaded a couple of days ago) and I have the same problem. However, even after I push OK when the message appears I have problems. It does not recognize the LPC-Link2 I have bought together with a NXP evaluation board.
I followed the instruction to install the driver, the LPC is correctly listed in the device manager but I cannot select "SWD over Link2" because it is simply not there... am I missing something? or has the "not authorized" error something to do with it?
I configured the switches as per NXP instructions... what can I attempt???
I tested 3 different PCs all run Win7 64 and they are all updated...

Cheers
GGD