Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - ALE_FM

#1
Can I programm P89V51RD2FA(new) devices with Flash Magic?

I can programm P89V51RD2FA devices, but recently I have received a new batch of devices and I can not programmed them. I think the problem is the new devices are P89V51RD2FA(new), but I don't know the differences between P89V51RD2FA(new) and P89V51RD2FA.

My provider tell me that they have programmed devices of the same production batch using Superpro USB series ISP programmer, but I can't using flash magic.

Can anyone help me?
#2
I use a PCB with an external Watchdog and Flash Magic tool to programm a P89C51RD2FA micro.
Before programming I disable the watchdog by setting a jumper in my programming PCB.
Everything is ok, an I can programm and reprogramm the micro several times.
But sometimes the communications with the micro is lost, anf after that I can no longer programm the same micro I could before.
It seems to me that the jumper in my PCB fails to connect while trying to programm the micro, and after that I have always the same message: "Unable to connect at the specific baud rate. Try reducing the baud rate. Reset the hardware into ISP mode again".
It is not a problem on my PC or in the cable, because when I put a new micro in the PCB and connect the jumper to disable the watchdog, everything is ok.
But, what can I do to programm again the first wrong micro?
I have tried with some ISP functios but always the same message is returned.
Is it a problem with the bootvector?