hi,
I programmed a 89LPC935 using an MCB900 just a few hours ago, i was using FM3.50 and a USB to RS232 convertor.
the program was running fine but when i tried to reprogram it a couple of minutes later, i could not communicate with the MCB900 board.
I have tried everything suggested in "andy eyre's read first tips" but nothing seames to help, also upgraded to FM3.71 but that doesn't help either.
Even when i tried to connect the board later on by using a real RS232 it didn't help.
any suggestions please?
thanks!
I programmed a 89LPC935 using an MCB900 just a few hours ago, i was using FM3.50 and a USB to RS232 convertor.
the program was running fine but when i tried to reprogram it a couple of minutes later, i could not communicate with the MCB900 board.
I have tried everything suggested in "andy eyre's read first tips" but nothing seames to help, also upgraded to FM3.71 but that doesn't help either.
Even when i tried to connect the board later on by using a real RS232 it didn't help.
any suggestions please?
thanks!