Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Amrita_lv

#1
I have bought 15 nxp89v51rd2; i am using flash magic (version 7.72) to program it; out of 15 mc only 5 mc got programmed; for rest of the micro controller i am getting the issue; It shows reset the device into isp mode now, then if I press reset, nothing happens. So I thought it as a bootloader problem and I downloaded the bootloader from your site and programmed the micro-controller using TOP Universal programmer; After that I put it back on target board and tried to re-program it, now again it shows "reset the device to isp mode now" and i press reset, it works and goes to "erasing device......" after that nothing happens, it can not erase the device.
So I thought it as a configuration bit issue and used the TOP universal programmer to read the config bit for good microcontroller and non-working microcontroller; I found the working micro controller has following configuration "0x60=22 and 0x61=42"; but the non-working micro controller shows "0x60=0f and 0x61=02".
I need your help to solve the issue