Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jjacobsen

#1
Here are 2 debug files.  The 'failed' one was generated when I tried to do ISP -> Read Device Signature.  The 'ok' one is when I did the same thing with the uVision debugger running.
Thanks for your help on this.
#2
I can load the flash on my LPC2106 board with the Philips LPC2000 Flash Utility.  When I use Flash Magic I get an autobaud failure.  I can only get Flash Magic to successfully communicate to my board when I am using a Keil ULINK2 and the uVision debugger is running (using secondary JTAG pins).  When the debugger is not running, Flash Magic will not work.  In both cases, DTR and RTS are high to begin with, as seen on the scope.  I have followed Keil's instructions on setting up Flash Magic and using the scondary JTAG.  I have 'use DTR and RTS to control RST...' checked in Flash Magic.  It's version 4.34.1437. 

I can continue to use the Philips utility but want to know why Flash Magic will not work.  Any ideas?