Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - amitoha23

#1
Can you please link me to a download of working software .  i have version 4,5 .
i am not sure they work properly as message jumps from time to time .
and a ch340 driver to win 7 64bit .
Thank you

Amit
#2
Hi Andy ,

the seller sent me new files and software , it seems to fix the device . what make me thinks that i can not trust the programming software i got from seller .
as it seems to be unstable , what software can i use to write Hex files to P89V51RD2 using ISP ? ( using USB cable with ch340 chip )

Best regards
Amit
#3
Hi Andy
well i did as in the guide for Fixing the SoftICE mode , how do i know it solved the problem ?
something is still wrong , the chip does not function properly ,  the ISP works . but it lost it original function .( the DMX300 display stopped working ).,

i will test it functionality today maybe just display issue .

Reagrds
Amit
#4
H Andy ,

i have managed to program the chip . thank you , but on the way i think i damaged to boot-loader . the chip seems to program successfully but it does not work  ,(it stopped working when i have tried to communicate with it ) i think by mistake i have used the P89C51 settings by mistake , i have read its a common issue , i have tried to follow a guide to repair it but i did not manged to understand what was going on at that guide .

just in case i have a parallel programmer (easypro90b ) can it help solve my problem ?
do you have a simple solution ?


Regards
Amit
#5
Hi Andy ,

i do not have any reset button on the card (DMX300 device )  how can i reset the CPU ?
in what pin  do i need to check " U " signal?

while playing with the boud rate it seems that i have changed somthing in the chip as its original software has been changed (it has stopped working ) .

Regards
Amit


#6
Hello , My name is Amit and i am new in this forum .

as i mentioned in the topic , i have a device called DMX512  . it a smart light controller .
i have tried to communicate with the controller according to manual . with out any luck  , i even got the chip to stop working while trying to communicate with it .
i have only tried to read data . 

the DMX512 use mini Usb which have only 4 pins (GND ,TXD,RXD,+5v) .
How do i get it to ISP mode ?

the USB driver in my computer seems to work as i can see the ch340 USB TO SERIAL in the device manager .
while using the flash magic i tried different baud rates , different Freq  ,and even different protocols. no luck with reading the chip (or programing it ) .

i have the original Hex File (of the DMX512 )  i would like to try and reprogram it to make the DMX work again . any help is welcome

Reagrds
Amit