Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - rbtamd

#1
Hi folks,

I was using flash magic 3.50 and It works good. I installed the latest version (3.59.227) and it can communicate with my system. I am using the same settings. I try to connect via hyperterminal, sending the "U" char and the boot loader echoes it. Is this a bug in this version of flash magic?

Thanks

Roberto
#2
LPC9xx/LPC9xxx / enter in icp in hot
December 04, 2006, 07:20:36 AM
Hi, exists some way to enter to the ICP mode in a system with a MCB900 board with the bridge without cut the power on the board? Can  "start bootloader" do it?

Thanks
#3
Feature Requests / Read device signature button
December 04, 2006, 07:03:10 AM
Hi, I use Flash Magic with MCB900 as ISP-ICP bridge. Many times, my devices doesn't enter in icp mode, then I must to check the device signature ever. In the menu ISP is the option to read it, but i think that it must to be a botton on the tool bar to do this with a single click.

Thanks
#4
LPC9xx/LPC9xxx / P89LPC908 and ICP
November 27, 2006, 10:42:18 AM
Hi folks, anybody knows how P89LPC908 enters to the ICP mode?
I have a LPC908 based board and I use the MCB900 modified to do the bridge. Sometimes when I try to program the device flash magic doesn't recognize the signature, then I must to power up again. I want to reduce this problem.


Thanks

Roberto Mu