Author Topic: How to report bug of FDI's USB-DONGLE?  (Read 5959 times)

frank

  • Jr. Member
  • **
  • Posts: 10
    • View Profile
How to report bug of FDI's USB-DONGLE?
« on: July 08, 2008, 07:50:41 pm »
I try to register FDI's forum, but it prompts "This forum is not accepting new registrations."

I found there is a bug in LPC900 ICP operating with FlashMagic when Blank Check.



make MCU alive!

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2160
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: How to report bug of FDI's USB-DONGLE?
« Reply #1 on: July 09, 2008, 08:37:41 am »
Have you tried emailing or calling them?

What problem are you seeing?

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com

frank

  • Jr. Member
  • **
  • Posts: 10
    • View Profile
Re: How to report bug of FDI's USB-DONGLE?
« Reply #2 on: July 10, 2008, 12:43:11 am »
When I do the "Blank Check" operating on a blank device, FlashMagic always returns "Not blank".

After doing the "Erase all flash" operating on a device, then I do the  "Blank Check"  operating on it, FlashMagic always returns "Not blank".





make MCU alive!

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2160
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: How to report bug of FDI's USB-DONGLE?
« Reply #3 on: July 11, 2008, 08:45:54 am »
Hmmm... that problem sounds vaguely familiar. Did you search on this forum? Are you using the latest version of Flash Magic? Have you checked if FDI has a firmware update for your dongle? Have you tried another device?

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com

Je Gold

  • Full Member
  • ***
  • Posts: 135
    • View Profile
Re: How to report bug of FDI's USB-DONGLE?
« Reply #4 on: July 12, 2008, 10:25:34 pm »
Which  micro are you using?

Which ICP schematic are you using? Have you checked the waveforms of the signals required to carry out ICP?

Do you think it is a hardware or software problem?  How have you come to this confusion?

Joe