How to Assert DTR and RTS using command line interface of Flashmagic?

Started by FrankWu, May 17, 2010, 02:55:04 AM

Previous topic - Next topic

FrankWu

Hello:

I want to use DTR and RTS to control power on, how to Assert DTR and RTS using command line interface without any UART activities on TX and RX.

Best Regards,
Frank

Andy Ayre

The only functionality in Flash Magic for DTR and RTS is what is documented. Namely using them to power up and reset a device into bootloader mode or asserting RTS the whole time the COM port is open.

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com

FrankWu

Dear Andy:

I have found out that FlashMagic Terminal could do what I want.
How to use the command line interface to execute Terminal fo FlashMagic?


Best Regards,
Frank

Andy Ayre

The functionality of DTR and RTS in the terminal should be the same as in the command line interface. However you cannot send/receive arbitrary data using the command line.

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com