Can't program 8051 micro controller using Flash Magic

Started by ashwin.metpalli, March 13, 2016, 10:07:26 AM

Previous topic - Next topic

ashwin.metpalli

Hi, I am trying to program 89V51RD2 micro controller using flash magic. When it asked to reset the device into ISP mode now, I pressed the reset switch on the development board but the message box still exists and the console shows "Attempting to Connect". I am using USB to Serial port connector and the cable is perfectly OK as I have validated loop back test with it.
Could you please help me on this.

Andy Ayre

There are lots of suggestions to debug this at http://www.flashmagictool.com/autobaud.html What have you tried and what were the results?

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com