Author Topic: Cannot program SST89E516RD2  (Read 462 times)

gauravkothari23

  • Jr. Member
  • **
  • Posts: 1
    • View Profile
Cannot program SST89E516RD2
« on: July 08, 2017, 05:29:59 am »
hi all...
i am working on a project where i have to use SMD 44 pin TQFP SST89E516RD2 microcontroller. i am using TTL converter to program this controller using RX and TX pins. but i am not able to program the controller. i am using flash magic to program. when i press start button from the software it says RESET TO ENTER ISP MODE. but when i reset the controller, nothing happens. i have checked all the connection and also the connectivity. connected RX pin to controller TX pin and TX to controller RX pin. also only TX led glows in TTL converter.
i tried changing around 4 boards but non of them are working. but the same if i try programming the DIP package, it programmes without any error.

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2121
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Cannot program SST89E516RD2
« Reply #1 on: July 10, 2017, 07:38:38 am »
For ST parts you will need to use an ST programming utility. Flash Magic is for NXP only.
Embedded Systems Academy, Inc.
support at esacademy dot com