General > General Discussion

Silent Instal FlashMagicProdSys

(1/1)

da_migel:
Hello,

i need to install Flash Magic Production System in silent mode. I already found the command line switches and the official documentation / help of command line arguments.

However, i get the following Dialog:
'The activation code is not valid for this product. Please contact the vendor where you purchased this product'

If i install the setup manually and enter my activation code everything works fine. I already tried to get that information i the setup-config file with /SAVEINF= and /LOADINF=

Is there a way passing the registration code to the installer?

Thanks for help,
Markus

Andy Ayre:
If you install in silent mode how will the end user accept the license agreement?

da_migel:
Hello Andy,

with some installers u can either tell them where a license file is located, save it in a config-file where other information are stored aswell or using a switch like --acceptlicense

However, i am pretty sure the license agreement can be disabled with a switch already (/SUPPRESSMSGBOXES should do it imo)

Andy Ayre:
The point isn't to disable or hide the license agreement, it is to make the user accept it.

Navigation

[0] Message Index

Go to full version