Author Topic: Silent Instal FlashMagicProdSys  (Read 901 times)

da_migel

  • Jr. Member
  • **
  • Posts: 2
    • View Profile
Silent Instal FlashMagicProdSys
« on: January 22, 2018, 01:53:25 am »
Hello,

i need to install Flash Magic Production System in silent mode. I already found the command line switches and the official documentation / help of command line arguments.

However, i get the following Dialog:
'The activation code is not valid for this product. Please contact the vendor where you purchased this product'

If i install the setup manually and enter my activation code everything works fine. I already tried to get that information i the setup-config file with /SAVEINF= and /LOADINF=

Is there a way passing the registration code to the installer?

Thanks for help,
Markus

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2156
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Silent Instal FlashMagicProdSys
« Reply #1 on: January 22, 2018, 02:27:45 am »
If you install in silent mode how will the end user accept the license agreement?
Embedded Systems Academy, Inc.
support at esacademy dot com

da_migel

  • Jr. Member
  • **
  • Posts: 2
    • View Profile
Re: Silent Instal FlashMagicProdSys
« Reply #2 on: January 23, 2018, 01:09:18 am »
Hello Andy,

with some installers u can either tell them where a license file is located, save it in a config-file where other information are stored aswell or using a switch like --acceptlicense

However, i am pretty sure the license agreement can be disabled with a switch already (/SUPPRESSMSGBOXES should do it imo)

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2156
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Silent Instal FlashMagicProdSys
« Reply #3 on: January 24, 2018, 12:51:10 am »
The point isn't to disable or hide the license agreement, it is to make the user accept it.
Embedded Systems Academy, Inc.
support at esacademy dot com