In-System Programming Support > ARM Cortex

LPC11C24F programming

(1/76) > >>

selnet:
Hallo Dear
I have a problem .I have EPC V3 R5C and it has LPC11C24F .I have burnt the mcu with 30 volt supply voltage  after I  changed it. But it dosnt work .I've  loaded the hex file to the new mcu via Flashmagic .It doesnt seem any problem with program but the mcu doesnt work .Can anyone help or has any experience about this issue. Thanks in advance .Regards

Andy Ayre:
You have probably damaged it by applying 30V. It's far too much.

Andy

Navigation

[0] Message Index

[#] Next page

Go to full version