LPC11C24F programming

Started by selnet, February 03, 2018, 05:25:50 PM

Previous topic - Next topic

selnet

Hallo Dear
I have a problem .I have EPC V3 R5C and it has LPC11C24F .I have burnt the mcu with 30 volt supply voltage  after I  changed it. But it dosnt work .I've  loaded the hex file to the new mcu via Flashmagic .It doesnt seem any problem with program but the mcu doesnt work .Can anyone help or has any experience about this issue. Thanks in advance .Regards

Andy Ayre

You have probably damaged it by applying 30V. It's far too much.

Andy
Embedded Systems Academy, Inc.
support at esacademy dot com