Author Topic: Interfacing Flashmagic with KEIL  (Read 5232 times)

Mohit Gupta

  • Guest
Interfacing Flashmagic with KEIL
« on: May 22, 2003, 08:34:10 am »
I am now using phillips P89C51RD2HBP with flash magic.  I am compiling the C program using Keil software.

Now, I am able to do the ISP programming of the chip independently using flash magic software.  However, if I try to integrate the flash magic into the IDE of Keil, I am not able to do so.  

When I use the command
DEVICE(89C51RD2Hxx, 11.0592) COM(1, 19200) ERASE(0,PROTECTISP)
it erases the chip

However when I am using the command as given in the flash Magic manual section 9.2:
DEVICE(89C51RD2Hxx, 11.0592) HEXFILE(test.hex, NOCHECKSUMS,NOFILL) COM(1, 19200)

it gives the ERROR message:
ERROR: Invalid PArameters for HEXFILE directive: HEXFILE(d:\test.hex,NOCHECKSUMS,NOFILLS)

I have tried to give different combinations for the HEXFILE directive but the same message appears.

Please Help.

Andy Ayre

  • ESAcademy Staff
  • Sr. Member
  • *****
  • Posts: 2156
    • View Profile
    • Embedded Systems Academy, Inc.
    • Email
Re: Interfacing Flashmagic with KEIL
« Reply #1 on: May 22, 2003, 08:40:06 am »
I see in your error message you have the parameter "NOFILLS", but it should be "NOFILL". Check you did not enter it incorrectly.

Also, later versions of Flash Magic require a fourth parameter called protectisp, described fully in the manual. Normally this will be set to "PROTECTISP", so try:

HEXFILE(d:\test.hex, NOCHECKSUMS, NOFILL, PROTECTISP)

Always make sure you check the manual and release notes for changes when updating to a new version of Flash Magic.

Embedded Systems Academy, Inc.
support at esacademy dot com

Mohit Gupta

  • Guest
Re: Interfacing Flashmagic with KEIL
« Reply #2 on: May 22, 2003, 09:16:02 am »
Thanks,  I am now able to link the flashmagic with KEIL IDE

Regards,

Mohit