I would try to run FM on the command line with my P89LPC932A1 but the connection failed each time.
My command line is FM COM(1,9600) Device(89LPC932A1,4.00) Blankcheck(0,0x1dff)
The answer is :
connection failed : unable to connect ( no response from device).
Is anybody could help me?
Thanks,
David
How are you placing the device into ISP mode? I.e. which method? Break condition? Pulse entry? Because the command line you are using assumes you are doing this yourself.
You might want to read about the HARDWARE directive in the manual.
I had not seen the HARDWARE directive.
Thanks,
David