I'm trying to program a LPC2138FBD64/01 using Flash Magic v5.40.1801, but the programming fails. I can read the device id and security.
Manual start of boot loader mode. (P0.14 low while Reset goes high)
1) Read Device Signature -> ok
2) Read Security -> ok
3) Start flashing -> Operation Failed. (programming - failed to send data to the device)
LPC2138FBD64/01
Device ID: 0x0002FF25
Bootloader Ver. 2.12
COM port 1.
Baud Rate 115200
Interface None (ISP)
Oscillator (MHz): 14.7456
Hex File: C:\ProgramTest.hex
I have tried other Baud Rates without any luck.
Regards
Bent Nielsen
Manual start of boot loader mode. (P0.14 low while Reset goes high)
1) Read Device Signature -> ok
2) Read Security -> ok
3) Start flashing -> Operation Failed. (programming - failed to send data to the device)
LPC2138FBD64/01
Device ID: 0x0002FF25
Bootloader Ver. 2.12
COM port 1.
Baud Rate 115200
Interface None (ISP)
Oscillator (MHz): 14.7456
Hex File: C:\ProgramTest.hex
I have tried other Baud Rates without any luck.
Regards
Bent Nielsen