I'm running FlashMagic 4.30.1363 trying to flash an LPC2478 with a hex file from Embedded Artists.
I have verified that I can talk to the LPC2478 through the COM port I'm using (COM4) - which is setup as a USB serial port. That is, I can connect to the port with Hyper Terminal at 115200, reset the board, and clearly read the startup boot text from the board inside the Hyper Terminal window.
But when I try to use FlashMagic I just get an error. I have the COM Port set to "COM 4" , I've tried all baud rates between 9600 and 115200, Device is set to "LPC2478", Interface is "None (ISP)", and I leave Oscilator at 16.0000 Mhz.
Yet whenever I click Start I get a dialog box that says "Operation Failed. (failed to autobaud - step 1).
Any ideas?
Thanks,
Serge
I have verified that I can talk to the LPC2478 through the COM port I'm using (COM4) - which is setup as a USB serial port. That is, I can connect to the port with Hyper Terminal at 115200, reset the board, and clearly read the startup boot text from the board inside the Hyper Terminal window.
But when I try to use FlashMagic I just get an error. I have the COM Port set to "COM 4" , I've tried all baud rates between 9600 and 115200, Device is set to "LPC2478", Interface is "None (ISP)", and I leave Oscilator at 16.0000 Mhz.
Yet whenever I click Start I get a dialog box that says "Operation Failed. (failed to autobaud - step 1).
Any ideas?
Thanks,
Serge