Topics

Hi, does someone know how to read Intel-hex files to do a remote serial software update?

Thanks

Piero

Hi, I was looking form some help to do my sw update arch. Can I erase the first block of my flash? I think that's dangerous, because after I've errased it in IAP and change the STATUS BYTE to NON CERO, so my programm can start at BOOT VECTOR = 0x8000; since then I can NOT acces to my micro (89C664) with ISP.

Is there a form to acces again to my micro? Don't tell me just with the parallel programming form, please!!!

I can't RUN my programm since I ERASED the first block... what a miss!!!

Thanks for your help.

Regards,

Piero