Dear Sir,
I am facing a problem, first i will explain my hardware, iam using P89C51RD2BN and handshake controls for to get into isp mode and i configured flashmagic settings also, and working well
but when iam trying to use hyperterminal for display "Hello world " program nothing is displaying,
later i connected (shorted) pins 1-4-6 and 7 -8, pins of 9 pin D connector at pc side, and removed handshake leads, then starts working displaying "hello world"
but keeping these connections along with handshake pins which are controlling ISP, interupting ISP system through handshakes, and my PSEN remains low, and RESET remains HIGH, this is causing system not working,
what can i do, to use both handshake based ISP control and serial programing,(terminal),.
thankyou,
PADMANABHAM
Try configuring Hyperterminal to use no flow control (i.e. ignore handshaking of any kind).
Dear sir,
You mean that shall i try without connecting (shorting) pins 7-8, 1-4-6
????????. and change settings of hyperterminal into no flow control????.
or shorting 7-8, 1-4-6 along with no flow control????. i already tried this, but this is giving problem, system going to reset mode, means reset pin remains high and psen pin remains low :(.
ok i will try first one only four wires, TX, RX, DTR and RTS and i configure hyperterminal to no flow control and i will come to you back, with results.
Regards
PADMANABHAM
i tested by setting flow control to none, but no use, and my one more observation is,
for testing this i have written a simple serial port routine on dos plat form using Turbo C, there i have configured MCR (MODEM CONTROL REGISTER) setting 0x00, BASE PORT +1, with value 0x00, then it starts working, and ISP and Mysimple terminal both working on same cable wiring, but still im getting problem due to flashmagic im working on windows environment and that too direct from uVision, and to run my terminal program im going to dos mode, after exiting from dos to windows mode then only flashmagic starts working other wise its showing error accessing COM port.
any way pls help me on this modem controll settings in hyperterminal or suggest me any other good terminal program (preferably freeware)
Thankyou,
PADMANABHAM
Try http://bray.velenje.cx/avr/terminal/
Direct pin manipulation (and many more interesting features) is implemented also in http://realterm.sourceforge.net/ , but its overall appearance is quite poor and is not easy to use (and has a - documented - flaw in sending binary files, it misses each $1A).
Jan Waclawek