Why are you giving 5V to pin 4?Usually you should follow this procedure:
1) Start flash magic
2) Reset the board or switch power off then to on again.
3) Download the HEX file.
Have you read the flash magic manual?
- Welcome to Flash Magic Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
P89V51Rx2/P89LV51Rx2 / Re: Could not able to download my HEX Code
September 12, 2007, 12:09:37 AM Why are you giving 5V to pin 4?Usually you should follow this procedure:
1) Start flash magic
2) Reset the board or switch power off then to on again.
3) Download the HEX file.
Have you read the flash magic manual?
Pages1