DEAR ALL,
I KNOW THAT THIS QUESTION IS NOT ABOUT FLASH MAGIC OR WINISP, BUT DOES SOMEBODY HAVE INFORMATION ABOUT HOW THE P89LPC632 CAN BE PROGRAMMED IN PARALLEL MODE ????
BEST REGARDS.
PASCUAL
I'm afraid that information is only given out by Philips. Please contact them at the following location for assistance:
http://tinyurl.com/8cx6
regards, Andy
ANDY, THANK YOU FOR THE ANSWER. HAVE YOU SEEN A FILE THAT IS IN KEIL
I cannot find that file on Keil's web site - can you point me to it?
The LPC932 is in-system-programmable as I'm sure you know. So all you need is to build an ISP circuit that matches Keil's MCB900 and use Flash Magic. You can get the Schematic diagram for the MCB900 from here:
http://www.keil.com/lpc/me900.chm
Or alternatively buy an MCB900 from your Keil distributor. I believe they are available now.
Andy
ANDY, IT IS: http://www.keil.com/dd/chip/3378.htm;
HERE, WHERE IT SAYS: FLASH PROGRAMMING.
THE MCB900, IS NOT AVAILABLE YET.
THANK YOU FOR THE INFORMATION, BUT ABOUT THE ISP, DO I NEED TO MAKE THE UART BREAK DETECT, IN MY SOFTWARE ??
THIS WEEK, I COULD NOT ANSWER YOUR QUESTION, BECAUSE I HAVE TO GO TO AN EXHIBITION CENTER. YOU CAN CONTACT ME AT THE FOLLOWING EMAIL: support@electronicdd.com.
BEST REGARDS.
PASCUAL
Pascual,
If you have revision C then you must enable break detect and use that to enter ISP mode. If you have revision E then you can either build the additional hardware to allow Flash Magic to generate the pulses on RST or enable the break detect.
If you want quick and easy generation of code for the UART including enabling the break detect option, check out Code Architect at:
http://www.codearchitect.org/philips
regards, Andy