Is it possible to update the bootloader for P89V51RD2 in the command line?
Is it also possible to set ISP entry mode in the command line?
If it is possible, please tell me the commands.
Thanks a lot!
Updating the bootloader requires a sequence of specific steps, therefore it currently isn't possible to do this on the command line.
To set the ISP entry mode use the CONFIG directive. See the manual for details. You need to pass a 16-bit value, which you should be able to find in the documentation for the bootloader. The lower byte specifies the ISP entry mode and the upper byte specifies the pin (if used).
Andy
Hallo Andy
Thanks a lot for your information
Hallo Andy,
do you know, when is it possible to update the bootloader in the command line?
Please tell me.
Thank You.
Sorry, we don't have any plans to add that at this time.
Andy
Thank You for Your information