I am using FlashMagic on one of my PC and it is working fine, on another one, it gives the following message>>
"Unable to connect at the specified baud rate. Try reducing the baud rate. Reset the hardware into ISP mode again."
On the other PC, even if the serial cable is not attached, it does not show any error message, just it tries to
connect and gives the standard message to "Reset the device in ISP mode."
On this PC, I've tried all from checking the cable, checking the baud rate, checking the port(working fine when checked in Hyperterminal).
Please suggest if any other possibility for such error.
"Unable to connect at the specified baud rate. Try reducing the baud rate. Reset the hardware into ISP mode again."
On the other PC, even if the serial cable is not attached, it does not show any error message, just it tries to
connect and gives the standard message to "Reset the device in ISP mode."
On this PC, I've tried all from checking the cable, checking the baud rate, checking the port(working fine when checked in Hyperterminal).
Please suggest if any other possibility for such error.