ifailed to program LPC2378 using USB-ICP-LPC2K and magic flash. i have done the following connections. flash magic always shows the step1 autobaud failed.
USB-ICP-LPC2K LPC2378
pin 1 3.3V
2 Reset (pin 24)
3 P2.10 (pin 76)
4 GND
5 RXD0 (pin 142)
6 TXD0 (pin 141)
i have done the following flash magic settings
COM port-COM7
Baud rate-9600
Device-LPC2378
interface-FDI USB-ICP-LPC2K
oscilliator-11.0592
flash magic always shows the step1 autobaud failed.
why does this error come?
kindly help to program the flash of LPC2378.
Thanks and Regards
You need to put a scope on the RxD and TxD pins on the microcontroller and see if any data is being sent or received. Let us know.
Andy