Text only | Text with Images

Flash Magic Forum

General => General Discussion => Topic started by: ctsuser on January 26, 2009, 12:02:41 PM

Poll
Question: How can config protection clear could be executed through the command line?
Option 1: N/A votes: 0
Option 2: N/A votes: 0
Title: config protection reset
Post by: ctsuser on January 26, 2009, 12:02:41 PM
I am using flash magic V4.16 and I am trying to find a way to clear the config protection through the command line but haven't able to do so.  Could any of you know how to do this?  If so could you please explain?
Title: Re: config protection reset
Post by: Andy Ayre on January 27, 2009, 08:04:17 AM
Which device are you using? Typically protection is removed using an erase of the entire device. But this depends on the specific device.

Andy
Title: Re: config protection reset
Post by: ctsuser on February 05, 2009, 10:21:34 AM
Andy,
           I am using the LPC952 device and I have used the erase(device, noprotectisp) command but it does not clear the CWP bit.  I would just nice to have a command that does the same thing as the clear config button in the GUI.  The fact is that with the application I am using it is much easier to interface with flash magic through the command line.  By the way, another issue I have seen with the newest version of flash magic  is that the interface type FDI USB-ICP has changed to FDI USBLPC9xxx, but when i used it.  It did not recognize the programmer.  Not sure what was that all about.  Anyway, I went back to the earlier version of Flash Magic and it works fine on that regard.


                                                                                                       Will Rodas                         
                               
Text only | Text with Images