I am using tx_miniicp
when I push start button, device started programming. when address came 0x1b40 flash magic software gave on the screen below message
device does support operation (program additional security)
what is the problem?
Thanks for interested
Open your hex file in Notepad and look to see if it has any records at the top of the 16-bit address spae, e.g. 0xFF00 and higher. If so then those are used to program things like additional security bits. This data is likely being generated by your startup code, so you will need to modify or comment it out there.
Andy
code 8kb but hexcode of lpc925
if any small hex file upload in the flash everthink ok
but orginal hex file can't upload
hex file is inpossible to do modify
what can ı do
This data is likely being generated by your startup code, so you will need to modify or comment it out there.
Andy