Print Page - p89lpc922fn

Title: p89lpc922fn
Post by: vijay on September 28, 2006, 09:22:04 AM

i would like to program p 89lpc922fn pl suggest how can program with flash magic

Title: Re: p89lpc922fn
Post by: Andy Ayre on September 28, 2006, 09:27:48 AM

First read through the user manual available from the NXP web site and decide which programming method you want to use, ICP or ISP. Next if you choose ISP decide which method you want to use to place the device into ISP mode (break detect, three pulse entry, Erik's No Touch).

Also read through the Flash Magic manual and the Flash Magic application notes.

Title: Re: p89lpc922fn
Post by: vijay on September 28, 2006, 10:13:11 PM

break detect, three pulse entry, Erik's No Touch what is the difference among three which is the simple methode

Title: Re: p89lpc922fn
Post by: Andy Ayre on September 28, 2006, 10:20:42 PM

It depends on your application, what you want to do for the hardware design, etc. There is an article/code for NoTouch at the bottom of the Flash Magic web page. The other methods are described in the user manual for the device.

Title: Re: p89lpc922fn
Post by: erikm on October 02, 2006, 07:21:07 AM

do note thet while 'the article' is about the Rx2 devices, it applies to the LPCs as well

Erik

Title: Re: p89lpc922fn
Post by: vijay on November 17, 2006, 08:32:04 PM

i would like to know what is errik's notouch. i can not find any arrtical on this.

Post Edited (11-17-06 22:18)

Flash Magic Forum

In-System Programming Support => LPC9xx/LPC9xxx => Topic started by: vijay on September 28, 2006, 09:22:04 AM