Hi, I developed a board with the NXP LPC55S69. I have already developed a program with the Xpresso IDE.
My applications runs fine withe the Segger Jlink Debuger on the SWD port.
I added the USB connection on USB1 of the device in the design.
I installed latest Flashmagic: 13.50 build 6367, it has USB driver 3.02 on windows 10
I enable the ISP with a jumper. Connect the USB ; from PC to my board. (Which also powers my PCB,)
I followed the setup of flashmagic: select USB LPC55S69. A hex file.
Device LPC55S69 (USB, LPC5500)
Interface tiegf6JWnvo5 (USB Bootloader)
reading Signatures works.
reading sectors data works
erasing sectors works.
But programming works not: (pressing START)
LPC55S69(USB, LPC5500) Operation Failed. (programming - failed to send data to the device)
In the Preferences:
hardware tab shows the UART selection bullets (as if the programmer will use UART? )
other tabs are default.
What is going wrong here? or do I do somthing wrong?
I enables debug mode, but can not find the debug file.
I found the debug file