The issue has been resolved after removing several unused background applications. (Skype, MSN messanger...) Looked like there was interference.
- Welcome to Flash Magic Forum.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
LPC2xxx / Re: problem programming FDI LPC2103 with FlashMagic and FDI USB_Dongle
November 04, 2010, 07:14:47 AM #2
LPC2xxx / problem programming FDI LPC2103 with FlashMagic and FDI USB_Dongle
November 03, 2010, 04:07:44 PM
Hi,
Tried to program FDI(Future Design) LPC2103 daughter board with their USB-Dongle and FlashMagic V5.71.2114. The outcome varied, sometimes successful, sometimes varing error message.
The development environment is Windows XP-SP3, Keil uVision4. The code size was about 800 bytes, just the toggling of LED(P0.6) and a software based delay. When the programming was successful, the LED blinking worked.
Is there any setting in the FlashMagic menu that I may try to improve the rate of success?
Thanks for helping,
Frank
Tried to program FDI(Future Design) LPC2103 daughter board with their USB-Dongle and FlashMagic V5.71.2114. The outcome varied, sometimes successful, sometimes varing error message.
The development environment is Windows XP-SP3, Keil uVision4. The code size was about 800 bytes, just the toggling of LED(P0.6) and a software based delay. When the programming was successful, the LED blinking worked.
Is there any setting in the FlashMagic menu that I may try to improve the rate of success?
Thanks for helping,
Frank
Pages1