Hi,
i use Flash Magic Version 5.12.1675.
My problem is, that i get a warning " failed to autobaud - step1".
STEP1
Device: LPC 2103
COM Port: 16
Baud Rate: 115200
Inteface: NONE(ISP)
Osc.:14.7456 MHz
Advaned Option
-> Hardware Config.
I see only ISP and not the Pin (P0.14) -> correct? ???
Can somebody help me?
Thanks
The DTR/RTS setting depends on your hardware. Or you can place the device into ISP mode manually. Check the manual for your hardware to determine which method to use. Use a scope to check that the conditions are being met at the device pins for ISP entry.
Andy