I am doing a project on Atmel t89c5115.
I have connected it to serial port of a computer through max 232. There is nothing wrong as per the connections are concerned.
I am using atmels FLIP software for ISP programming. But i am getting "Time out error" when i have tried to connect.
my pin 1.0 of the controller is pulled high by the hardware. does it cause any difference as far as the boot loader is concerned.
do i need to reset the contoller every time i try to do isp?
please help me out.
I am using atmels FLIP
so, you expect answers from a FlashMagic site?
Go to the flip forum (if there is one) no help here.
Erik
Erik
who the hell are u!
I am trying all the possible means...