Print Page - Can't program demo kit from Pictiva

Title: Can't program demo kit from Pictiva
Post by: prayami on July 16, 2007, 07:26:26 PM

Hi,
I got OLED demo kit from OSRAM Pictiva. Which has P89LV51RD2BBC. I have downloaded the flashmagic from this website. And trying to program but it is giving me the following error.
"Unable to connect at the specified baudrate. Start reducing the baudrate again. Reset the hardware into ISP mode".

I have selected baudrate to 2400. And it is giving the same error when I do:
ISP->Reset
ISP->Device Signature
ISP->Blank Check.

I am using COM port 1. With interface: (None)ISP. Erased all flash is checked. Verify after programming is checked.

I can't figure out what can be problem. We got ready made kit from OSRAM pictiva. Can there be problem in the hardware? What it can be? Please help.

Thanks,

Title: Re: Can't program demo kit from Pictiva
Post by: Andy Ayre on July 17, 2007, 09:39:42 AM

How are you placing the device into ISP mode? Pressing buttons?

Andy

Title: Re: Can't program demo kit from Pictiva
Post by: prayami on July 17, 2007, 11:30:00 AM

Thanks for reply,

In Interface drop down list, I have selected "None (ISP)". And from main menu, ISP tab(or what ever we say), I select blank check etc.
Is there any thing else I require to do?

Title: Re: Can't program demo kit from Pictiva
Post by: Andy Ayre on July 17, 2007, 11:56:20 AM

Go to Options -> Advanced Options

Is the option to use DTR enabled? If so uncheck it and try again.

When you click on "Start" a window should pop up telling you to reset the device. At that point you need to cycle the power on your board or press a button to reset the device.

Andy

Title: Re: Can't program demo kit from Pictiva
Post by: prayami on July 17, 2007, 12:54:27 PM

Thanks for reply, I can see the progress but not success.

I uncheck the option: Use DTR to control the RST. And now it is showing the message "Reset the device in ISP mode". Now I am turning the power ON here ( and also tried to reset while power ON and OFF both). But it is just hanging over there and not doing anything. I confirm the COM port number, reduced the baudrate. I can't figure out, what can be the problem.

Title: Re: Can't program demo kit from Pictiva
Post by: Andy Ayre on July 17, 2007, 01:09:20 PM

What crystal frequency are you using?
Are you leaving the "Reset device" window open for a while (more than 30 seconds) after powering on your board?

The correct sequence is:

Click on "Start" -> window opens with cancel button telling you to reset the device
Power on your board
Window should dissappear and the erasing/programming/etc starts

If this doesn't work then you will need to put a scope on the RxD pin on the device and check that 'U's are constantly arriving at the pin.

Andy

Flash Magic Forum

In-System Programming Support => P89V51Rx2/P89LV51Rx2 => Topic started by: prayami on July 16, 2007, 07:26:26 PM