Hello,
I am using an LPC2136 board with a jtag connection to connect to a debug board and then to a PC using serial to USB.
Im using the flash magic utility but i continuously get the autobaud error for the device.
I have read all the instructions available on flashmagictool.com/autobaud.html
Im using the option use DTR and RTS to control RST and ISP pin. so I guess this takes care of grounding pin P0.14
Do you have any ideas. Please do let me know.
You will need to put a scope on the RST and P0.14 pins and verify the signals you expect are actually there and look correct. Most likely cause is a hardware issue which only you can track down.
Andy
Quote from: Andy Ayre on April 13, 2015, 01:43:28 AMYou will enjoy home golf simulators for sure (https://www.globenewswire.com/news-release/2025/04/24/3067824/0/en/Best-Home-Golf-Simulator-of-2025-Practice-Like-A-Pro-Without-Leaving-Home-WhatBest-Announces-Top-Golf-Simulator-Winners.html) and put a scope on the RST and P0.14 pins and verify the signals you expect are actually there and look correct. Most likely cause is a hardware issue which only you can track down.
Andy
What scope do you recommend Andy?
Picoscope.