Print Page - Can't wake up my MCU

Title: Can't wake up my MCU
Post by: Dorian VIDAL on June 09, 2005, 02:45:01 AM

Good morning

I use the MCB900 prototype board (revision E).

uvision2 V2.37

Flash magic V1.71 (DLL Version 1.41)

MCU P89LPC932B A
CB8146.W17
TI0309 XE

My source code is in assembler (.a51)

When I debbug my code with

Title: Re: Can't wake up my MCU
Post by: Andy Ayre on June 09, 2005, 08:01:42 AM

This discussion forum is specifically for ISP related issues. If you code is executing then you might be better off posting your question on the discussion forum at 8052.com.

Flash Magic Forum

In-System Programming Support => LPC9xx/LPC9xxx => Topic started by: Dorian VIDAL on June 09, 2005, 02:45:01 AM