Flash Magic Forum

In-System Programming Support => LPC2xxx => Topic started by: deep5811 on August 31, 2006, 09:44:30 am

Title: Programing a LPC2294
Post by: deep5811 on August 31, 2006, 09:44:30 am
I was just wondering if it is possible for me to retrieve flash and program flash from the LPC2294 using the Flash Magic software.  The only way i can talk to the processor is through the debugger port.  Any help is greatly appreciated.  Thank you.
Title: Re: Programing a LPC2294
Post by: Andy Ayre on August 31, 2006, 09:51:22 am
Flash Magic works with the ISP bootloader, which uses an on-chip UART. If you can connect to it and the code read protection is not enabled, then you can save the contents of flash as a hex file using FM.