Print Page - FLASH PROGRAMMING

Title: FLASH PROGRAMMING
Post by: harnamt on October 11, 2006, 03:40:06 AM

Respected All,

I am using P89V51RD2 for making a project. The project includes the data to be written in the EEPROM of the microcontroller.

Could you please guide me how can I write in FLASH MEMORY using the FLASH MAGIC.

Is it required to invoke the BOOT LAODER for doing this.

I dont have the parallel programmer.

regards
H S Thakur

Title: Re: FLASH PROGRAMMING
Post by: Andy Ayre on October 11, 2006, 07:13:34 AM

The method of placing the device into ISP mode is described in the datasheet. Basically you need to reset the device then start using Flash Magic. Flash Magic will send a stream of 'U's and ask you to reset the device.

Title: Re: FLASH PROGRAMMING
Post by: Jan Waclawek on October 13, 2006, 12:44:13 AM

Dear H S Thakur,

If it's not you or your colleague asking there - there is a discussion on the very same topic running currently on 8052.com's forum: http://www.8052.com/forum/thread.phtml?thread=126180

Jan Waclawek

Flash Magic Forum

In-System Programming Support => P89V51Rx2/P89LV51Rx2 => Topic started by: harnamt on October 11, 2006, 03:40:06 AM