Flash Magic Forum

General => General Discussion => Topic started by: gates2231 on July 01, 2007, 10:11:08 PM

Title: Basics
Post by: gates2231 on July 01, 2007, 10:11:08 PM
Hello
my name is chinni krishna
i am a +2 student going for engineering in ECE stream
i am using a P89V51RD2 MCU on a board bought frm TRI Techno solutions
i am a good programmer of C and C++

my problem is i am not able to understand anything about microprocessors
i don't know where to start
so plz kindly suggest me good books tat makes me understand micros fully and tat can get me into the position of implementing my own circuit boards
plz help meeeeeeeeeeeeeee
Title: Re: Basics
Post by: launchck on August 12, 2008, 04:13:36 AM
hi im in the same boat, send me if u gt anythin.
cheers...
Title: Re: Basics
Post by: erikm on August 12, 2008, 06:04:58 AM
no better plae to start than "the '51 bible"
Chapter 1 - 80C51 Family Architecture:
http://www.nxp.com/acrobat_download/various/80C51_FAM_ARCH_1.pdf

Chapter 2 - 80C51 Family Programmer's Guide and Instruction Set:
http://www.nxp.com/acrobat_download/various/80C51_FAM_PROG_GUIDE_1.pdf

Chapter 3 - 80C51 Family Hardware Description:
http://www.nxp.com/acrobat_download/various/80C51_FAM_HARDWARE_1.pdf

Title: Re: Basics
Post by: MarkW on August 25, 2011, 03:50:09 AM
Similar question as 2 members above. But, erikm resolved this very successfully. Thank you erikm!  :)