Print Page - Problem with USB(FTDI FT232BL)

Title: Problem with USB(FTDI FT232BL)
Post by: kezlok on August 08, 2009, 10:42:44 AM

Hi
I am writing because, I need latest version Flash Magic eg. 4.35m. I have problem with my LPC2148. I don't connect by USB my test board. I Always give this same error "Failed To Autobaud". Computer detect device- Serial port and USB serial Converter(chip USB<=>UART is FTDI FT232BL ) but I don't have a communication with uC.

Title: Re: Problem with USB(FTDI FT232BL)
Post by: Andy Ayre on August 10, 2009, 09:18:28 AM

4.35 isn't the latest version.

Depending on which USB port you used the COM port number can change. Check in the device manager the COM port number by disconnected and reconnecting the cable while watching the hardware list.

Also see: http://www.flashmagictool.com/autobaud.html

Andy

Flash Magic Forum

In-System Programming Support => LPC2xxx => Topic started by: kezlok on August 08, 2009, 10:42:44 AM