Text only | Text with Images

Flash Magic Forum

In-System Programming Support => ARM Cortex => Topic started by: samson.bunty on November 03, 2012, 09:53:28 AM

Title: Support in ISP for LPC1765 Using flash magic
Post by: samson.bunty on November 03, 2012, 09:53:28 AM
Hi Everyone,

Am new to this,Am using NXP LPC1765 controller,am doing insist programinng using flash magic. But i had a problem in that. After programming the controller is not booting(not going to user application mode). I have disabled the isp pin once i finished the programing. I have checked with Scope the Tx & Rx pins of the controller. the data is transfering. Both pins Tx & Rx are working fine. Kindly suggest me what will be the problem here? Will it be Software Issue or Hardware Issue??

Thanks in advance

Regards,
Samson 
Title: Re: Support in ISP for LPC1765 Using flash magic
Post by: Andy Ayre on November 05, 2012, 12:34:23 AM
If it is not executing your firmware does that mean the bootloader is still executing?

Andy
Text only | Text with Images