Hi all,
I am new to NXP.
I have purchased MCB1800 development kit and using keil ide to compile the sample blinky code provided for this board with keil ide.
I have used flash configuration to program this code into internal flash memory of the LPC1857.
I have downloaded this code with the help of UART0 and flash magic.
I am not able to see program running.
For verification i have look at the data in flash memory with the help of flash magic and have found that it stores image.
Do i miss any settings on MCB1800 board or anythins is required from flash magic side to make it work.
Regards,
Lalit Shah
Check/tick "Activate Flash Bank" in section 4 of the main window before clicking on "Start".
Andy